
version 1.1
28
8. If the system fails to contact the preprogrammed personal telephone number 1, system will
contact PERSONAL TELEPHONE NUMBER 2 as a back up.
9. To exit user programming mode, press [MODE] followed by [#] key.
[30] + [#]
1. Ensure that the system is in USER PROGRAMMING mode.
2. Enter [30] for personal telephone number 1 setting.
3. Enter the [#] key to erase previous personal telephone number 1 setting.
4. To exit user programming mode, press [MODE] followed by [#] key.
[31] + [PERSONAL TELEPHONE NUMBER 2] + [#]
1. Ensure that the system is in USER PROGRAMMING mode.
2. Enter [31] for personal telephone number 2 setting.
3. Enter the [PERSONAL TELEPHONE NUMBER 2], the maximum telephone number length
is 14 digits.
4. Button “P” on the keypad is representing a “PAUSE” key of 5 seconds duration.
5. Button “M” on the keypad is representing a “
” key.
6. Enter [#] key to confirm the setting.
7. If programmed so, system will call out to user telephone to report any intrusion.
8. The USER TELEPHONE NUMBER 2 is a back-up reporting telephone number. System will
only call through USER TELEPHONE NUMBER 2 if it fails to report through USER
TELEPHONE NUMBER 1 during intrusion. If the system fails to report through both of the
telephone numbers, a new trouble condition will be registered (please refer to View System
Trouble).
9. To exit user programming mode, press [MODE] followed by [#] key.
[31] + [#]
1. Ensure that the system is in USER PROGRAMMING mode.
2. Enter [31] for personal telephone number 2 setting.
3. Enter the [#] key to erase previous personal telephone number 2 setting.
4. To exit user programming mode, press [MODE] followed by [#] key.
TO ERASE PERSONAL TELEPHONE NUMBER 2
TO ERASE PERSONAL TELEPHONE NUMBER 1
PROGRAM PERSONAL TELEPHONE NUMBER 2 (BACK
Comentarios a estos manuales